RAJACK Offset Pivot Hinge | D1 x B1 Bottom of Door

OFFSET PIVOT HINGES

by RAJACK

D1 x B1 Bottom of Door Setup

B1 Surface Mounted

Install Option A

D1

B1

v1

v1-1

Door Undercut

v1-2

X

This page contains illustrations and general placement instructions for the D1 x B1 offset pivot hinge for the bottom of your door. Once RAJACK has all of your specific door information we can recommend hinge material sizes and projections. Please use the links above for detailed cut sheets of each material size offered for this hinge setup. RAJACK can accommodate most custom hinge requests.

The B1 pivot portion mounts below the door aligned with the D1 pivot portion. The B1 can be surface mounted onto the floor (see Install Option A) or mortise flush into the floor (see Install Option B). Its important you determine the desired undercut spacing for your door. We will make the appropriate height pivot pin, bushing and spacer to accommodate the specified door undercut.

The D1 pivot portion is mortised flush to the bottom of the door (see v3). The D1 is mortised into the center of the doors thickness. Changes can be made to the material size, projection and placement of the pivot hinge if need be at time of order.

RAJACK Offset Pivot Hinges are manufactured in different material sizes to accommodate small cabinet doors up to full size doors. You can find a hinge material size chart on the Offset Pivot Hinge main page.

If you have any additional questions or would like a formal quote for your project please email info@rajack.com.